FMM Style Mill Couplings
The FMM Kind coupling consists of one particular regular flex hub, 1 universal straight bored hub as standard, two sleeves and one accessory kit. This coupling is provided with exposed bolts as typical. Shrouded bolts are available on request by size five.5.
Capabilities
For long lifestyle
Standard 20° pressure angle
Heat taken care of bolts for greater strength
Corrosion resistant bolts and nuts for ease of upkeep
Gives parallel, angular misalignment and finish float
Flex Half coupling interchangeable with sector requirements
Prolonged Universal Hub supplied to customer specs with straight or tapered bores
Ordering Data
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is needed.
Specify counterbore dimensions if desired.
Submit a drawing if readily available.

FHDFS Sort Floating Shaft Couplings
The FHDFS Kind coupling consists of two flex-rigid couplings and 1 floating shaft. The coupling is supplied with the rigid hubs outboard except if otherwise specified. The coupling comes with exposed bolts only.
Capabilities
Flex Hubs for long daily life
Regular 20° pressure angle
Heat handled bolts for greater power
Corrosion resistant bolts and nuts for ease of maintenance
Accommodates parallel and angular misalignment
Elimination of center assembly makes it possible for forease of upkeep with out repositioning machinery
Rigid hubs outboard makes it possible for for bigger shaft diameters
Developed for high-torque low-speed applications that take place in mill operations
Ordering Facts
Application: Driver and Driven.
Sort and size of coupling, horizontal, vertical etc.
Electrical power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Connecting gear shaft sizes.
Specify which hubs are to get utilized on the equipment (Rigid or Flex).
Rigid hubs is going to be employed within the equipment unless of course otherwise specified.
Length of floating shaft may possibly have an impact on max angular misalignment.