January 19, 2021

Material Managing Power UNIT 2
General Description
This energy unit capabilities electrical power up gravity down circuit. Activate the start solenoid to start the motor to lift the machine. The lowing movement is activated through the solenoid valve using the lowering speed managed by the stress compensated movement manage valve. Products of this series is usually broadly utilized in the field of logistic units for example fork lift, mini lift table, and so forth.
Unique Notes
one. The duty of this energy unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean the many hydraulic elements concerned prior to mounting the electrical power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities, N46 hydraulic oil is suggested .
4. Oil transforming is required following the original a hundred operation hrs,afterwards when just about every 3000 hours.
five. The electrical power unit must be mounted horizontally.

Materials Dealing with Electrical power UNIT 1
Standard Description
This electrical power unit is intended for the fork lift industry, consisting of hugely productive gear pump, DC motor, manual increase and reduce valve, tank, ect. The up and down motion are managed by the lever in the manual release valve, that’s outfitted with an electrical switch to activate the motor. The lowing pace is managed through the stress compensated movement handle valve.
Particular Notes
1. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean all of the hydraulic components concerned in advance of installation of the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which should also be clean and totally free of impurities, N46 hydraulic oil is suggested .
4. Oil modifying is needed immediately after the preliminary 100 operation hours, afterwards when every 3000 hours.
5. The energy unit shown is made to be mounted horizontally.

Leave a Reply

Your email address will not be published. Required fields are marked *