ep

February 24, 2021

Observing a handful of guidelines for appropriate installation is important on the reliable and appropriate operation on the gearbox or gear motor.
The principles set out listed below are meant as being a preliminary manual to selecting gearbox or gear motor. For successful and right set up, stick to the instructions given within the installation, use the maintenances manual for that gearbox available from our product sales division.
Following is usually a brief outline of installation rules:
a) Fastening:
Place gearbox on the surface giving satisfactory rigidity. Mating surfaces needs to be machined and flat.
Mating surfaces must be within definite geometric tolerances (see guide). This is particularly correct of flange-mounted gearboxes with splined hollow shafts.
In applications that involve large radial loads at the output end, flange mounting is recommended for some gearbox sizes as this mounting can make use of the double pilot diameters offered in these gearboxes.
Ensure that the gearbox is suitable for that needed mounting place.
Use screws of resistance class 8.eight and over to secure the gearbox. Torque up screws to the figures
indicated while in the related tables.
With transmitted output torque better than or equal 70% from the indicated M2max torque, and with
regular motion reversals, use screws with minimal resistance ten.9.
Some gearbox sizes can be fastened making use of both screws or pins. Of pin seated while in the frame the gearboxes be no less than 1.5 occasions pin diameter.
b) Connections
Safe the connection parts to gearbox input and output. Will not tap them with hammers or very similar equipment.
To insert these elements, make use of the services screws and threaded holes offered about the shafts. Be sure you clean off any grease or protects from the shafts prior to fitting any connection components.
Fitting hydraulic motors.
Be cautious the O ring in between motor flange and gearbox input flange when assembling. Install the
hydraulic motor just before filling lube oil in to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit must be such to guarantee that brake is released instants before gearbox commences and applied right after gearbox has stopped. Test that stress inside the hydraulic line for brake release is at zero each time gearbox is stopped.
Route of rotation
Motors are connected on the suitable electric or hydraulic circuit in line with their course of rotation.
When performing these connections, keep in mind that all gearboxes, irrespective of whether while in the in-line or right angle style, possess the exact same route of rotation each at input and output. For additional specifics of your connection of electrical and hydraulic motors, see appropriate sections on this catalogue.

Leave a Reply

Your email address will not be published. Required fields are marked *